• 14 dages fortrydelsesret
  • Fri fragt over DKK 699,-
  • Fragt fra 49,-
  • Dansk Kundeservice
Menu
Login
Bliv kunde
Søg
Min kurv items vare
  • Forside
  • Brodit Aktiv Holder m. USB-A Host til Honeywell EDA 10A - 712403
Brodit Aktiv Holder m. USB-A Host til Honeywell EDA 10A - 712403
Brodit Aktiv Holder m. USB-A Host til Honeywell EDA 10A - 712403 Image Image

Brodit Aktiv Holder m. USB-A Host til Honeywell EDA 10A - 712403

Ikke på lager. Forventes afsendt inden for 2-4 hverdage, hvis du bestiller nu.
SKU
712403
2.149,00 DKK

Nem og hurtig levering

Bestil i dag inden 15.00 og vi sender i dag.(Postnord og Kl. 13 med GLS).

Sikker og tryg betaling

Krypteret betalingssystem, der beskytter dine oplysninger.

100% Dansk Kundeservice

Vi hjælper gerne med at finde den rigtige løsning til dig.

14 dages returret

Returnér nemt inden for 14 dage, hvis produktet ikke lever op til dine forventninger.

Høj kvalitet, lang holdbarhed

Fremstillet af førsteklasses materialer, der sikrer lang levetid.

Topanmeldelser på E-Mærket

Vores kunder elsker os – se vores fremragende anmeldelser på E-Mærket.

Beskrivelse

Active holder with cig-plug
Fits devices with Protective Boot (EDA10A-RB-0) and Rotating Hand Strap (EDA10A-HS-1PK). With USB Host Type-A. With Easy-switching system. Charger via pogo pins. With AMPS, VESA 75.

Use an active holder for your EDA10A and you will always have a freshly charged battery! The holder provides a neat and comfortable installation - safe and convenient. The holder is equipped with a cig-plug for connection to the vehicle's 12/24 Volt socket. 3A charging. Charging via pogo plug. The holder is equipped with a USB-Host port so you can connect an accessory.

This holder is to be used when you want to have your EDA10A extra securely in place and still have it easy accessable.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Choose installation placement with care, devices must not be placed in positions where they may block the view or important controls. The cradle should only be attached onto a suitable place. Installations always take place at the customer's own discretion and responsibility.

Fits the following models
Honeywell EDA10A 

Spørgsmål til produktet
Spørgsmål til produktet